Alctron MA614B Mikrofonní stojan-stolní

Velmi stabilní

Celkově konstrukce je dobrá, robustní, drží v něm těžký mikrofon dostatečně pevně. Nicméně při polohování ramenem je slyšet nepříjemný skřípavý zvuk, tím pádem nevhodné pro živé vysílání či nahrávání, kde je potřeba hýbat s mikrofonem. Původně jsem myslel, že to může být zimou nebo vada jednoho, ale udělala to 3 ramena, tím pádem to bude asi jejich záporná vlastnost.

Splnil očekávání tak na 90 %. Klouby se v trubkách stiojanu trochu viklají a pružiny při manipulaci lehce vržou (ale snad se časem oběhají).

Ottimo supporto ad un prezzo ragionevole

Disappointing. Pros: - Clean Aesthetics - Has a built-in, internally routed XLR mic cable - Can support heavy mics / setups (with caveats, see below) Cons: - Surprisingly heavy / hard to work with. I expected smooth adjustment, but this is the opposite: you can get your daily workout just trying to adjust it. Because the spring tension is so high, you need to have the nuts on its joints locked at any time and you really need to tighten these until your hand hurts. This then makes on-the-fly adjustments impossible, you are fighting it at all times. As a consequence: - The base clamp is too weak for the stand's weight and stiffness and gets easily dislodged, even if you tighten it up until it hurts. It doesn't help that it has a felt pad on the inside - this slips easily on smooth surfaces. I replaced it with silicone pads on both sides, otherwise the stand is nearly unusable and dangerous. The clamp has arm holes that would normally allow you to attach it on both horizontal and vertical surfaces, but the hole for vertical setup is way too close to the surface you are clamping to - and that doesn't allow the chunky base of the arm to fit. This is compounded by the base joint having a very limited adjustment angle. - The mic head does not turn at all. Not sure if it's jammed on mine, or bad design. So you can't rotate the mic once attached, unless you partially unscrew the mic. - I chose this over desk stands that have springs on the outside to avoid unwanted noise/resonance. Sadly, the joints are loose and rattle unless tightened, so do the metallic inserts. It luckily doesn't rattle when fully tightened, but as mentioned this completely eliminates any adjustments. My advice, save your money and look elsewhere.